asperities

英 [æsˈpɛrɪtiz]

美 [əˈspɛrɪtiz]

n.  (尤指语言、态度)粗暴，严厉
asperity的复数

双语例句

• The size of the peaks, or asperities, depends on the material and the method of surface finishing.
  峰或突起的大小与材料和表面抛光方法有关。
• If the gouge layer is thin, contact between asperities on the rock surfaces can occur.
  如果充填物层很薄，两个岩石表面上的凸起物就有可能互相接触。
• In this paper, a three-dimensional measuring system for surface asperities is described, in which a microcomputer is interfaced to a stylus profilometer.
  本文介绍采用触针式轮廓仪与通用微型机相连的表面三维形貌测量系统。
• Merchant thought that minute asperities existed at the chip-tool interface and the fluid was drawn into the interface by the capillary action of the interlocking network of these surface asperities.
  Merchant认为：在切屑与刀具接触界面上存在微小的粗粒，切削液通过这些表面的微小粗粒组成连锁的网络的毛细管被吸入到切屑与刀具的接触界面上。
• The experiments indicated that asperities of roll surface plow and stick to the aluminum strip surface, and lubrication oil film in deformation zone shields surface topography of aluminum strip are the primary reasons of surface damage of cold rolled aluminum strip.
  实验发现：轧辊表面微凸体对铝板表面的犁削与粘结作用，以及变形区内润滑油膜对铝板表面形貌的屏蔽作用是冷轧铝板表面损伤的主要原因。
• The larger the surface roughness and the sharper the asperities, the greater the asperity contact load.
  表面越粗糙、表面凸峰越尖锐，微峰接触载荷则越大。
• She was oppressed by an abiding sense for the asperities and inequalities of society.
  她深受压抑，长期因社会的冷酷和不公深受困扰。
• Based on the number of asperities on the fault plane, the asperity model was classified into three models: all-asperity, single-asperity and multi-asperity models.
  根据凹凸体的数量将凹凸体模型分为三种模型：所有凹凸体，单凹凸体和多凹凸体。
• However, at higher angle of tooth-shaped asperities and under higher normal stress, the failure model II is found, which is in first tension but final shear failure.
  在较高的法向应力下，含起伏角较高齿形节理面的非贯通节理岩体可能出现破坏模式II（先张拉后剪切破坏模式）。
• The relationship between sliding friction force and contacting condition of rough surfaces was developed according to kinematics and dynamics analysis of two contacting asperities.
  从一对微凸体的接触力学和运动学分析出发，建立了非流体动力润滑条件下粗糙表面滑动摩擦阻力与粗糙表面接触状态间的关系。